HXLONG
|
|
|
|
|
Dart Board Set Up
The Location of the Dart Board
The board should be setup in a safe place away from windows, breakables and
also so no one could accidentally walk into the playing area during play. A
light above the board should be mounted so not to interfere with a dart in motion
or cast shadows on the board. The best way would be to place it on the ceiling
approximately 18-24 inches in front of the board or use a special light that
mounts on the backboard.
How to Care for a Dart Board
The board will wear uneven due to the nature of the game with the 20 section
being used the most. To avoid this from happening it is a good idea to rotate
the ring occasionally. The board should be replaced when the ware and tear on
it affects the game such as the bull, double and triple ring area will not hold
a dart.
Throwing Distances
American Steel Tip
The center of bull should be 5' 8" ( 173 cm ) of the floor and the oche
or throwing line should be 7' 9 1/4" ( 237cm ) from the front face of the
board. This should leave an exact line of 9' 7 1/2" ( 294 cm ) from the
oche to the center of the bull which is used to avoid variations from an uneven
floor which could be the case in older bars.
European Distances
The throwing distances vary and can be as far as 9' for special events.
How to Setup a Dartboard (Steel-Point).
The Official throwing distance, for most countries, is 2.37 meters, as measured
along the floor, from the plane of the face of the dartboard. In feet, this
is 7 feet, 9-1/4 inches. The height of the board, to the center of the bull,
is 173 centimeters, or 5 feet, 8 inches. Most importantly is the diagonal measurement-
from the center of the bull to the throwing line (oche). That should measure
9'7 3/8"
[SITEMAP]
